Multi-Master Multi-Slave Config
| MMMS_ENABLE | Configuration bit to enable MMMS functionality |
| DISABLE_CONN_REQ_PARAM_IN_MEM | If set to 1’b1 and MMMS enabled, then the parameters received in connection request are not stored in CONN_REQ_PARAM memory. By default this bit is 1’b0 and the connection request parameters are stored in connection memory. This bit is intended as a fail-safe. Should not be changed dynamically during runtime |
| DISABLE_CONN_PARAM_MEM_WR | By default on end_ce, the connection parameters memory is loaded with the updated connection parameters. Setting this bit prevent’s this update. This bit is intended as a fail-safe. Should not be changed dynamically during runtime |
| CONN_PARAM_FROM_REG | By default the parameters for the connection are picked up from the connection parameters memory. Setting this bit disables this and the parameters are picked up from registers 0 - HW loads the parameters from connection memory 1 - Firmware should program the paramters for the connection event This bit is intended as a fail-safe. Should not be changed dynamically during runtime |
| ADV_CONN_INDEX | This field specifies the connection index for which ADV is enabled |
| CE_LEN_IMMEDIATE_EXPIRE | Enable for CE length immediate expiry |
| RESET_RX_FIFO_PTR | Setting this bit resets the receive FIFO pointers |